HDPE drainage dimpled membrane for foundation dampproofing and wall waterproofing
Product introduction
Drain Board is made from HIPS or HDPE, and is formed as dimple shape. There are filtration geotextiles on the top of dimples to prevent silt passing through the drain board so that the drainage system will not be obstructed. Traditional drainage method is using the cobblestones or gravels as the filter layer to drain the water to the designated place. Using drain board to replace cobblestone filter layer is more economical and practical, also can reduce the load of the construction.
Technical parameter
| |
| | |
Tension at 10% elongation (N/100mm) ≥ | |
Maximum pulling force (N/100mm) ≥ | |
| | |
| | |
| | Maximum strength when compression rate is 20%/KPa ≥ | |
Extreme compression performance | |
Low temperature flexibility | |
| | Tensile retention at 10% elongation≥ | |
Maximum tensile retention rate/(N/100mm) /% ≥ | |
Elongation at break retention rate /% ≥ | |
Maximum strength retention rate when the compression rate is 20% ≥ | |
Extreme compression performance | |
Low temperature flexibility | |
Longitudinal water flow (test pressure 150KPa) (cm²/s) ≥ | |
Product Application Range
1. Greening project: the garage roof greening, roof garden, vertical greening, roof greening, football pitches, golf course, etc.
2. Municipal engineering: airport, road embankment, subway, tunnel, landfill, etc.
3. Construction: the upper or lower building foundation, inside and outside the basement wall, floor and roof, roof seepage
control and heat insulation layer, etc.
4. Water conservancy project: the reservoir seepage water, reservoir, lake water seepage control, etc.
5. Traffic engineering: highway, railway basement, roadbed, dam and slope protection layer, etc.
Product Tags:
|
|
HDPE Dimpled Drainage Membrane For Foundation Dampproofing And Wall Waterproofing Images
|
